Procuct Detail
1/6
$5.49
L298N Dual H Bridge DC Stepper Motor Drive Controller Board Module, 5V-35V
Discount & Coupons
Coupon
$8 OFF Order Over $200 (exclude smartphone)
Shipping
to Exclusive Estimated Delivery Time:
Weight
0.035kg (0.077lb)
Recommendations For You
Product Attribute
Type : Drive IC
Condition : New
Application : Other
Supply Voltage : 5V-35V
Dissipation Power : 25W
Operating Temperature : -20℃ to +135℃
Model Number : L298N
is_customized : Yes
Package : SOP

Parameters:

Working mode: H-bridge drive (two-way)
Main control chip: L298N
Logic voltage: 5V
Driving voltage: 5V-35V
Logic current: 0mA-36mA
Drive current: 2A (MAX single bridge)
Storage temperature: -20 ° C to +135 ° C
Maximum power: 25W


Product features:

1. Using L298N made by ST company as the control chip,the module has such characteristics as strong driving ability, low calorific value and strong anti-interference ability.

2. This module can use built-in 78M05 for electric work via a driving power supply part.But to avoid the damage of the voltage stabilizing chip,please use an external 5V logic supply when using more than 12V driving voltage.

3. Using large capacity filter capacitor,this module can follow current to protect diodes,and improve the reliability.


Real figure

L298N is a kind of high voltage, high current motor driver chip produced by ST company.Having 15 pins as package, this chip has such features as high working voltage(maximum voltage up to 46V), large output current(instantaneous peak current up to 3A, continuous working current 2A) and 25W of rated power.Two built-in H birdge high voltage and large current full bridge drivers can be used to drive the DC motor and stepper motor, relay coil and so on.Using standard logic level signal control, it has two enable control ends. It permits or prohibites device having a logic power supply input without the impact of input signal, which enables the internal logic circuit part works at low voltage. The chip can connects to external detecting resistor to give the variations to the control circuit. Using L298N chip to drive the motor, this chip can drive a stepping motor or four phase stepping motor, and two DC motors as well.
Port function
Circuit principle diagram
This module is integrated with a built-in 5V power.When the drive voltage is 7V-35V, it can enable the onboard 5V logic power supply; afterthe power supply, don't input voltage in the interface+5V power supply, but you can lead the 5V for external use.
when ENA enable IN1 IN2 control OUT1 OUT2
when ENB enable IN3 IN4 control OUT3 OUT4

Applied cases:

1 Driving stepper motor
The connection of driving a common 4 line 2 phase electric motor is shown in below figure after enable ENA ENB
Input the following driving timing from IN1-IN4?then the speed and direction of the stepper motor can be controlled

Packaging Details
  • Unit Type:piece
  • Package Weight:0.035kg (0.077lb)
  • Package Size:13cm x 10cm x 1cm (5.12in x 3.94in x 0.39in)
Price Drop Alert
If the product price is lower than the price you set within 90 days, vwe will notify you by email
Please enter your desired price
Please enter your email
Cancel
Confirm
Shipping
Ship to:
Shipping Methods
Shipping Service Shipping Cost Estimated Delivery Time Tracking Information
Please note:the standard and ecpedited shipping costs are only estimates;the actual shipping price will be shown on the order page.
Cancel
Confirm
Selected
$ 5.49
Selected: Red x 1
Quantity:
Cancel
Confirm
Discount & Coupons
Coupons